MODELS:
DF30 – DF36 – DF48 – DF60 DF30-3 – DF36-3 – DF48-3 – DF60-3 DF30-4 – DF36-4 – DF48-4 – DF60-4
MODEL ATTRIBUTES:
DIAGNOSTIC MODE:
INITIATING DIAGNOSTIC MODE:
To initiate Diagnostic Mode, oven control knob bezel must be in the OFF position. Now, press and hold CLOCK key and TIMER key for 3 seconds. (See Figure 3-60)
The ambient cavity temperature will be displayed in the temperature readout knob. Now, turn the oven temperature readout knob to the right seven separate times, this will toggle from error code 1 thru 7. (See Figure 3-62)
To return to error code number one, turn oven temperature readout knob to the left seven separate times. (See Figure 3-63)
The software version will be displayed in the hours and minutes display of the clock. (See Figure 3-64)
KEEP IN MIND:
MISTAKE INDICATIONS:
Error codes can give a visual and also audible alarm. The aesthetic indicator will be “Err” shown in the Cook Time figures as well as the number or letter of the error code will be displayed in the Quit Time numbers of the Electronic Control Housing. The Stove Temperature level Readout Handle will also reveal “Err” in the display screen window. The last 7 mistakes will be kept in the EEPROM for recall when in analysis mode.
ERROR CODE | POSSIBLE CAUSE | TEST / ACTION |
2 | Over temperature occurs when the oven reaches a temperature of 630 °F for an unlocked door and 950°F for a locked door | Ohm RTD sensor, replace if defective. If RTD good replace oven controller. |